Home About Us MSDS PRODUCTS Contact Us Sample Request

JEFFCO 9700FCR

Epoxy Novolac Coating System

Back to Civil Engineering page

System SKU: 9700FCR
System Category: Civil Engineering

DESCRIPTION: Jeffco 9700-FCR is a high quality epoxy novolac coating system with chemical, high temperature, and abrasion resistance superior to Bis-A type epoxy resins. This tightly crosslinked system cures in the presence of moisture and humidity with excellent mechanical properties. It contains no solvents (100% solids, zero VOC) or carcinogens and has minimal odor and toxicity that assures ease of application. 9700FCR’s viscosity is well suited for vertical applications. Jeffco 9700FCR is typically stocked in gray and ships DOT non-corrosive. APPLICATIONS: - Tank Lining - Secondary Containment Coating - Floor Coatings  SUGGESTIONS FOR USE: Follow general surface preparation and application procedures specified in ACI 503.1-4. Do not apply to concrete less than 30 days old. Do not apply to concrete with curing or sealing membranes. Do not apply to substrates at a temperature less than 50°F. SURFACE PREPARATION: Substrate surfaces must be structurally sound and free from contaminants such as dust, oil or dirt. Surfaces must be shot blasted or mechanically abraded to achieve a minimum 5-mil profile. Coated surfaces must be mechanically cleaned and abraded with 60-80-mesh. A calcium chloride “dome” test is recommended and hydrostatic pressure must be <5 psi before epoxy coating application. Free-standing water must be removed. Do not apply over old epoxies or other previously applied coatings. Thorough and complete mixing is critical, a Jiffy mixer is recommended. First mix each component separately. Proportion each component at the ratio of 2 parts A (resin) to 1 part B (hardener) by volume or, if using 1-gallon kits, pour all of Part B (hardener) into Part A (resin) and mix at 400-600 RPM for 3-5 minutes. Use an up and down motion, scraping the mixing container sides and bottom. Mix no more material than may be applied in 20 minutes. PRIMING: Best results are obtained using Jeffco 1500 series H20 based epoxy primers first. 1500 series primers should be applied at a rate of 250 - 300 sq.ft. per gallon. FLOOR COATINGS: 9700FCR is an excellent bonding, medium viscosity, chemically resistant protective floor coating. It is a thixotropic, moisture insensitive coating that can be applied by roller, brush, or squeegee. This allows 9700FCR to be used in vertical applications. It will not crater or blush, drying to a high gloss. Also makes a great floor coating that will protect concrete in areas were high concentrations of chemicals are used. Jeffco polyethylene beads or other non-skid material may be broadcasted into 9700FCR to achieve a non-slip surface. ADVANTAGES OF JEFFCO: Solids by Volume 100% Volatile Organic Content (VOC) 0 lbs./gal Application Temperature 55°F minimum, 100°F max Maximum Re-coat Time @ 77°F 24 hours Dry To Touch @ 77°F 8 hours Light Traffic @ 77°F 14-16 hours Full Cure @ 77F 7 Days

CURED PHYSICAL PROPERTIES OF NEAT RESIN:

SUPPLIED AS PACKAGED KITS:
1 gallon, 3 gallon, 15 gallon, 165 gallon

Back to Civil Engineering page

The information contained herein is offered without charge for use by technically qualified personnel at their discretion and risk. All statements, technical information and recommendations contained herein are based on test and data which we believe to be reliable, but the accuracy or completeness thereof is not guaranteed and no warranty of any kind is made with respect thereto. Always read, understand, and comply with hazard warnings described in the products' Material Safety Data Sheet(s) before use.