JEFFCO 1308-NC
Low Viscosity GP Epoxy Resin
Back to
Resins page
Product Description:
Low viscosity, economical, general purpose epoxy resin with lowest toxicity and odor of any epoxy resin type. Viscosity similar to laminating polyesters allowing fast and efficient wetting of reinforcement materials. Higher physicals than competitive resins due to lower reactive diluent content. 100% solids, non-crystallizing. Zero VOC’s.
Product Uses:
Hand lay up laminating, adhesives, crack repairs, mortars and penetrating sealers.
|
| PROPERTIES OF 1308-NC RESIN (neat): |
Minimum |
Maximum |
|
Viscosity: |
500 |
700 |
|
EEW units: |
201 |
207 |
|
Weight Units: |
9.26 |
9.26 |
|
Colors: |
2 (Gardner) |
|
Mixing:
Recommend JEFFCO 1308NC be used between 65° -85° F (product and ambient temperatures). Use below 45° F requires special hardener selection, consult with Jeffco sales personnel for low temperature recommendations. Remove all surface contaminates such as water, dirt, rust, and petroleum products. Mold surfaces must be waxed or otherwise "released" prior to epoxy application. All Jeffco curing agents are compatible with JEFFCO 1308NC so proportion resin and hardener in accordance with the selected Jeffco hardener. Mix resin and hardener for 3-5 minutes being certain to scrape the bottom and sides of the mixing container. Mix no material than may be applied before the expiration of the pot life.
Curing:
JEFFCO 1308NC cures overnight at typical ambient temperatures (65° -85° F) with full properties developing in 7 days, see hardener data for specific cure schedules and properties.
How Supplied:
Gallons, Pails, Drums
Back to
Resins page |
The information contained herein is offered without charge
for use by technically qualified personnel at their discretion and risk.
All statements, technical information and recommendations contained herein
are based on test and data which we believe to be reliable, but the accuracy
or completeness thereof is not guaranteed and no warranty of any kind
is made with respect thereto. Always read, understand, and comply with
hazard warnings described in the products' Material Safety Data Sheet(s)
before use.
|
