JEFFCO 1367-L16
Epoxy Resin for Coatings
Back to
Resins page
Product Description:
High performance, low viscosity epoxy resin containing proprietary reactive diluent for maximum property retention. Contains surfactants for minimal surface imperfections. 100% solids, no VOC’s, very clear, highly resistant to crystallization, low odor and skin toxicity, DOT non-regulated.
Product Uses:
Clear coatings, mortars and grouts, crack injection and hand lay-up laminating.
|
| PROPERTIES OF 1367-L16 RESIN (neat): |
Minimum |
Maximum |
|
Viscosity: |
1,100 |
1,300 |
|
EEW units |
189 |
195 |
|
Weight Units: |
9.3 |
9.3 |
|
Colors: |
Clear, slightly translucent liquid |
|
Mixing:
Recommend JEFFCO 1367-L16 be used between 65° -85° F (product and ambient temperatures). Use below 45° F requires special hardener selection, consult with Jeffco sales personnel for low temperature recommendations. Remove all surface contaminates such as water, dirt, rust, and petroleum products. Mold surfaces must be waxed or otherwise "released" prior to epoxy application. All Jeffco curing agents are compatible with JEFFCO 1367-L16 so proportion resin and hardener in accordance with the selected Jeffco hardener. Mix resin and hardener for 3-5 minutes being certain to scrape the bottom and sides of the mixing container. Mix no material than may be applied before the expiration of the pot life.
Curing:
Recommend JEFFCO 1367-L16 be used between 65° -85° F (product and ambient temperatures). Use below 45° F requires special hardener selection, consult with Jeffco sales personnel for low temperature recommendations. Remove all surface contaminates such as water, dirt, rust, and petroleum products. Mold surfaces must be waxed or otherwise "released" prior to epoxy application. All Jeffco curing agents are compatible with JEFFCO 1367-L16 so proportion resin and hardener in accordance with the selected Jeffco hardener. Mix resin and hardener for 3-5 minutes being certain to scrape the bottom and sides of the mixing container. Mix no material than may be applied before the expiration of the pot life.
How Supplied:
Pails, Drums
Back to
Resins page |
The information contained herein is offered without charge
for use by technically qualified personnel at their discretion and risk.
All statements, technical information and recommendations contained herein
are based on test and data which we believe to be reliable, but the accuracy
or completeness thereof is not guaranteed and no warranty of any kind
is made with respect thereto. Always read, understand, and comply with
hazard warnings described in the products' Material Safety Data Sheet(s)
before use.
|
